*Complete fill will empty trans and empty converter is 5.3 liters according to the “book”.** A used trans will never be empty though.* *Iġ.***** Car must be cold, and level.* I do this on the ground.*Ģ.***** After pan drop install filter and stand pipe.* Then put check/drain plug in a few turns by hand.*Ĥ.***** Install scan tool, turn key on and get scan tool communicating with trans computer.*ħ.***** If trans was just replaced then put in another 3 liters.* If you just serviced it then pull check plug and immediately reinstall it.* If fluid doesn’t come out add another 1/2 liter.* The pump will be filling the converter with fluid from the pan and you don’t want the pan to run dry.* I use a small shallow pan to keep fluid from running on the floor.*Ĩ.***** When data shows 35 degrees Celsius then pull check plug. ![]() **Quite a bit of the converter fluid will drain out when the valve body is pulled. ![]() With filter change you’ll need 3 liters but its best to have 4 on hand just in case.* With valve body change you’ll probably need 4 liters but its best to have 5 on hand just in case. It’s slightly different than you might find elsewhere.* OEM procedure isn’t wrong but it’s confusing and lots of folks end up slightly low.* The temp will be in Celsius.įrom coolairvw 's website, you really should check it out-he even has helpful pictures for idiots like me Transmission section start at 000 hit the up arrow I think it is group 3 or 4 I don't remember right off.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |